How it works

A controlled stretch, measured in pressure and in pictures

Motorized spinal decompression uses a powered table. You lie on a pad. A harness holds you still. The table applies a pulling force. These tables are an FDA Class II device, 21 CFR 890.5900.

What the table is doing

The pull is along the length of the spine. For the low back, the pelvis or the lower trunk is the part that moves. The aim is to unload the segment your provider has chosen, while you rest.

Researchers have looked at that unload in two concrete ways. One team put a pressure transducer in a lumbar disc. Other teams took CT or MRI pictures and measured disc height or the size of a herniation. Those are the mechanisms this page describes, in the words the measurements support.

Close view of a padded table and a soft harness, as the table sections ease apart.

What the measurements show

Pressure inside the disc, disc height on CT, and a herniation index on MRI. Each block names the kind of evidence.

Pressure measurement

Effects of vertebral axial decompression on intradiscal pressure

A cannula in the L4–5 disc was connected to a pressure transducer while the person lay prone on a vertebral axial decompression table, with a pelvic harness attached to the table. Intradiscal pressure showed an inverse relationship to the tension applied. Tension in the upper range decompressed the nucleus pulposus to below −100 mm Hg. (Ramos and Martin, 1994 on PubMed)

CT imaging before and after a treatment period

Restoration of disk height through non-surgical spinal decompression is associated with decreased discogenic low back pain: a retrospective cohort study

In a retrospective review, without a comparison group, of 30 adults with chronic low back pain attributed to disc herniation and/or discogenic low back pain (average age 65; 21 women and 9 men), pain during a flexion-extension evaluation moved from 6.2 (SD 2.2) to 1.6 (SD 2.3) on a 0 to 10 verbal rating scale (p < 0.001). Disc height on CT moved from 7.5 (SD 1.7) mm to 8.8 (SD 1.7) mm (p < 0.001). The increase in disc height and the reduction in pain were correlated (r = 0.36, p = 0.044). The authors reported non-surgical spinal decompression associated with a reduction in pain and an increase in disc height. (Apfel et al., 2010 on PubMed)

MRI

Effect of spinal decompression on the lumbar muscle activity and disk height in patients with herniated intervertebral disk

The trial enrolled 31 people, ages 35 to 50, with lumbar and radicular leg pain and more than one bulging disc on MRI. The authors also describe the group as patients with lumbar herniated discs. Fifteen received decompression therapy plus trunk stabilization exercise. In that group the disk herniation index moved from 284 ± 12.3 to 198 ± 22.6. The authors reported that the index decreased significantly (p < 0.01) and that the difference in the change between the decompression group and the comparison group was significant (p < 0.05). (Kang et al., 2016 on PubMed)

All of the study notes are on the research page.

How the tables are regulated

These tables are an FDA Class II device, 21 CFR 890.5900. That is not an FDA approval that the table treats a named condition. (21 CFR 890.5900)

Ask your provider about spinal decompression